The best brush for a Bloodhound is a medium flat slicker used lightly on the body, backed by a long tooth comb for the ear leather. The coat is short, hard and dense, so almost nothing on a Bloodhound mats. The ears do, and they are the part most owners never brush.
That is the whole shape of Bloodhound grooming. Half an hour a week clears an astonishing volume of short hair off a dog this size, and five minutes of that half hour belongs to two heavy, low hanging ears that sweep the ground on every walk.
If you want the tools first, the medium flat slicker and the long tooth comb below are the two that do nearly all of it. Everything else in this guide is about where to put them.
Why the Right Brush Matters on a Bloodhound Coat
A Bloodhound carries a short, hard, close lying coat over a very large frame. Each hair is barely an inch long, so there is no length for a tangle to form in and no soft undercoat for loose hair to pack into.
What there is instead is quantity. An adult can weigh over a hundred pounds, and a hundred pounds of short coat sheds more hair by weight than a small dog with three times the length. Owners are often surprised by how much comes off a dog that looks like it needs nothing.
The brush matters for two reasons, and neither of them is mats. It lifts the shed hair out before it reaches the sofa, and it is the only routine that puts a hand over every inch of a very big dog once a week.
- A short hard coat releases hair steadily all year rather than in two annual blows
- The sheer surface area of a Bloodhound makes a weekly pass worth doing properly
- Loose skin hides lumps, ticks and hot spots that a brushing pass will find
- Nothing on the body needs detangling, so the pass can be quick and light
How a Bloodhound Sheds and Where the Hair Collects
Shed hair on a short coated dog does not stay in the coat the way it does on a double coated one. It works its way out and lands wherever the dog has been, which is why a Bloodhound household finds hair in food, bedding and car seats rather than in knots on the dog.
There are still places it lingers. Anywhere the coat sits under something or changes direction, the hair has to be pushed out rather than falling out.
The pattern is predictable once you know it, and it is almost the opposite of the pattern on a long coated breed.
- The neck and shoulders: heavy loose skin folds over itself here, and shed hair collects in the troughs between the folds.
- Under a collar or harness: a strap holds the coat flat against the skin and stops loose hair lifting out at all.
- The ear fringes: the longer, softer hair at the edge of each ear leather holds shed hair, debris and moisture together.
- The back of the thighs: the coat is slightly longer here on most Bloodhounds, and it is the first place a slick looking dog feels gritty.
The closest comparison on the site is another short coated hound with heavy ear leather, and Best Brush for a Beagle works through the same shedding pattern on a much smaller dog.
Why the Ears Are the Real Grooming Job on a Bloodhound
A Bloodhound ear is not a flap. It is a long, low set, heavy leather that hangs well below the jaw, and on a working dog it is dragged through grass, water, mud and whatever the dog is following. The breed is built that way on purpose, because the ears help funnel scent toward the nose.
Two things follow, and both are grooming problems rather than coat problems. The hair at the ear fringe is longer and softer than the body coat, so it is the only hair on the dog that can mat. The leather itself traps moisture against the skin underneath.
The brush is not the tool for any of this. A slicker on ear leather is uncomfortable, because the skin there is thin and sits directly over cartilage with nothing to cushion it. A comb worked gently through the fringe, and a damp cloth on the leather itself, is the correct pair.
The general case for ear hair is covered in Why Mats Behind Ears Happen, which is worth reading for the mechanism. On a Bloodhound the difference is scale: the ear is longer, heavier and wetter than on almost any other breed, and it swings on every stride.
- Comb the fringe, never brush the leather with a slicker
- Dry the inside of each ear after swimming, rain or a wet walk
- Check for heat, smell or head shaking and see a vet rather than cleaning harder
- Lift both ears and look under them at least once a week
What a Realistic Bloodhound Grooming Routine Involves
The routine for this breed is short and frequent rather than long and occasional. Once a week is enough for the coat, and the ears want looking at more often than that, especially in warm or wet weather.
Most of the time goes on the body because there is so much of it. Keep the pressure light, because a Bloodhound carries loose skin that moves under the brush and a heavy hand drags skin rather than coat.
- Once a week: a full light slicker pass over the body, following the lie of the coat, then a comb through both ear fringes.
- Two or three times a week: lift each ear, look and smell, and wipe the leather with a damp cloth if it is dirty.
- After every wet walk: dry the ears and the chest, and run a hand over the neck folds to check nothing is damp underneath.
- Every month or two: a bath if the dog genuinely needs one, which on a short coat is far less often than owners expect.
Recommended Tools for a Bloodhound Coat and Ear Leather
Three tools cover a Bloodhound properly, and one tool many owners buy for a big shedding dog is the wrong choice here. There is no undercoat on this breed to rake out, so a bladed deshedding tool has nothing to work on and everything to cut.
We make a Dematting Rake and it is a good tool on the breeds that need one. A Bloodhound is not one of them, and this is the honest version of our range rather than a sales pitch.
Flying Pawfect Flat Slicker Brush
The Flat Slicker Brush is the right geometry for a Bloodhound body. A flat head sits level against a short close coat, so every pin in the field carries the same share of the load and no corner digs in. On a coat this short, even pressure is the whole safety argument.
Take the medium rather than the large. That sounds wrong on a dog this size, and it is the one place where the usual rule about matching head size to dog size does not hold. The areas that actually need working on a Bloodhound are the neck folds, the chest and the base of each ear, and none of them is wide enough to steer a large head into.
The pins are fine bent stainless steel, densely set, which is what lets a short coat release its loose hair without the tool having to be pressed. Let the weight of the brush do the work and move it in the direction the coat lies. If you can see the skin moving under the brush, you are pushing too hard.
Used once a week over the whole dog, it takes about ten minutes and it removes a genuinely surprising amount of hair. It is also the fastest skin check you will ever do on a large dog, because the brush tells your hand about every lump and scab before your eyes find them.
- Best for: the weekly whole body pass on a short, hard, close lying coat.
- Why it works: a flat pin field spreads the load evenly so nothing digs into loose skin.
- Size to choose: medium, because the working areas on a Bloodhound are narrow even though the dog is not.
- Where not to use it: the ear leather, inside any skin fold, and anywhere you can feel skin through the coat.
Flying Pawfect 4-in-1 Dog Shampoo and Conditioner
A Bloodhound does not need bathing often, but when one is needed it is usually needed properly. This is a breed that follows its nose into water, mud and worse, and a short coat holds odour closer to the skin than a long one does.
The 4-in-1 cleans and conditions in one step, which keeps the dog wet for less time. That matters on a hundred pound dog with heavy ears, because the longer a bath runs the more water finds its way into places you then have to dry.
It is pH balanced for dogs, uses plant derived cleansers and organic ingredients, and is free of dyes, SLS, parabens, phthalates and alcohol. It is made in the USA. Rinse thoroughly in the neck folds, because trapped shampoo under loose skin is its own problem.
- Best for: the occasional real bath a scent hound earns, rather than a routine wash.
- Why it works: cleaning and conditioning in one step means less time wet and less to dry.
- Pay attention to: rinsing the neck folds and drying inside both ears afterwards.
- How often: only when the dog is actually dirty, which on this coat is rarely.
Flying Pawfect Long Tooth Comb
On most breeds the comb is the tool that checks whether the brushing was deep enough. On a Bloodhound it has a job of its own, and it is the ear fringe.
The longer softer hair at the edge of each ear leather is the only hair on the dog that mats, and it is exactly where a slicker should not go. A comb worked slowly from the tip of the fringe inward lifts out the shed hair, grass seed and grit without touching the leather itself.
The second job is the neck. Parting the loose skin folds with a comb and looking down into them is the only way to see whether anything is damp, rubbed or sore under there, and on a breed with this much skin it is worth doing every week.
- Best for: the ear fringes and parting the loose skin on the neck and shoulders.
- Why it works: teeth reach into fringe hair and into a fold where a brush cannot go safely.
- Technique: start at the tip of the fringe and work inward in short sections.
- What it tells you: whether the skin under a fold is healthy, which you cannot judge by looking.
Step by Step: Brushing a Bloodhound Without Pressing on Skin
A Bloodhound will usually lean into a session and go to sleep, which makes it easy to stop watching your own pressure. Work to a fixed order and the whole dog is covered in about ten minutes.
- Start at the shoulder: light strokes in the direction the coat lies, letting the brush weight do the work, and watch whether the skin moves with it.
- Work backwards along the body: ribs, flank, back and then the back of the thighs, which is where the coat is slightly longer.
- Do the chest and front legs: the dog is usually happy standing for this, and the chest is where a harness line shows.
- Finish with the comb on the ears: put the brush down, lift one ear at a time, and comb the fringe from the tip inward.
The same light touch logic applies to any short coated breed, which is why a Bloodhound routine looks a lot like a Labrador one on the body and nothing like it on the ears. If you want the comparison, Best Brush for Labrador Retrievers works through the short double coat version of the same problem.
Preventing Matted Ear Fringes and Damp Skin on a Bloodhound
Prevention on this breed is almost entirely about moisture rather than tangles. A dry Bloodhound in a clean house needs very little. A wet one that has not been dried properly can develop a sore patch under an ear or inside a neck fold within a day or two.
The habits that matter are small and quick, and none of them involves more brushing.
- Dry both ears and the chest after every wet or muddy walk
- Comb the ear fringes weekly so shed hair never has time to pack
- Keep a cloth by the door for the leather and the chin after drinking
- Check under every fold on the neck once a week with the coat parted
Drool is part of the grooming job too. Water sits on the chin and the ear tips after every drink, and a fringe that is repeatedly left damp stays damp. A cloth is a better answer than a brush.
Common Mistakes Bloodhound Owners Make With a Brush
Most Bloodhound grooming mistakes come from treating a very large dog as a very hairy one. The coat is the easiest part of this breed and the ears are the part that gets forgotten until something is already wrong.
- Buying a deshedding rake: there is no undercoat here for one to lift, so it can only scrape the skin and cut the guard hairs.
- Brushing the ear leather: the skin is thin and sits over cartilage, so a slicker there is genuinely uncomfortable.
- Pressing harder to get more hair: on a short coat the extra hair comes from the skin, not the coat, and the brush starts to sting.
- Cleaning a smelly ear instead of calling: heat, odour or head shaking is a vet question, and scrubbing can make it worse.
The last one matters most. A Bloodhound ear is a warm, dark, poorly ventilated space that gets wet often, so ear trouble is common in the breed and not something to groom your way out of.
FAQs
What is the best brush for a Bloodhound?
A medium flat slicker brush used lightly, with the weight of the brush and no added pressure. A flat pin field spreads the load evenly across a short close coat, and the medium head is easier to steer into the neck folds and around the base of each ear than a large one.
How often should I brush a Bloodhound?
Once a week is enough for the coat, and ten minutes covers the whole dog. The ears want checking two or three times a week, and combing once a week, which is a separate job from brushing the body.
Do Bloodhounds shed a lot?
Yes, steadily all year rather than in seasonal blows. The hairs are short so they do not show as clumps, but a dog of this size produces a large volume of them, and a weekly brushing pass removes a great deal before it reaches your furniture.
Can I use an undercoat rake on a Bloodhound?
No. A Bloodhound has a single short coat with no soft undercoat underneath, so a rake has nothing to lift and its blades reach straight to the skin. Flying Pawfect makes a Dematting Rake and it is the wrong tool for this breed.
Do Bloodhound ears need special care?
Yes, and they are the main grooming job on the breed. The ears are long, heavy and low set, so they drag through wet grass and water, and the fringe hair at the edge is the only hair on the dog that mats. Comb the fringe weekly and dry inside the ears after wet walks.
Why does my Bloodhound smell even after a bath?
A short coat holds odour close to the skin, and on this breed the usual sources are the ears, the lip and neck folds, and a coat that was not dried fully. If the smell comes back quickly or is coming from one ear, see a vet rather than bathing again.
Should I brush a Bloodhound before or after a bath?
Before. Brushing first lifts out the shed hair so it does not go down the drain or redistribute itself through a wet coat, and it also gives you a chance to find anything on the skin before it is hidden by water.
Is a slicker brush safe on loose skin?
Used lightly, yes, and that is the reason to choose a flat head rather than a curved one here. Keep the brush moving with the lie of the coat and stop if you can see the skin dragging under it rather than the coat lifting off it.
Final Thoughts
A Bloodhound is an easy coat and a demanding pair of ears. The body wants ten light minutes with a medium flat slicker once a week, and almost nothing on it will ever mat. The ears want a comb, a cloth and a habit of looking.
Get those two jobs separated in your head and the breed is genuinely low maintenance. Confuse them, and you end up brushing a coat that did not need it while a fringe quietly felts and a damp ear goes unnoticed.
![[CL] Flying Pawfect coral large flat slicker brush for dogs](http://flyingpawfect.com/cdn/shop/files/CoralLarge2026.jpg?v=1783693245&width=400)
![[BL] Flying Pawfect baby blue large curved slicker brush for doodles and long haired dogs](http://flyingpawfect.com/cdn/shop/files/CBL_HERO_26_05_819be2a4-36dd-43dc-bda3-1730fa9e5818.jpg?v=1784475444&width=400)
